Harmonic Resolution Systems MXR Audio Stand User Manual
Page 9
Install all eight 1/4-20 x 3/4" screws to the brace (see Photo 10) until they are fully
engaged but do not torque the screws at this time. You will want to leave them just
loose enough so that there is a very small amount of play to complete balance of
assembly. All the screws for the brace system will be fully tightened at a later point
in the assembly process. If they are tightened at this time, you may not be able to
complete assembly or it will not be level when complete. You will need to use the
Allen wrench (or ratchet wrench) at the location closest to the frame because the T-
wrench will hit the frame preventing screw rotation.
Photo 10
Repeat the panel brace installation procedure for the second brace at the top of the
panel (see Photo 11). Orient the HRS logo so that when the stand is sitting on its
feet the HRS logo will be right side up and in proper orientation. Make sure that
all eight screws are completely installed on each of the two panel blocks (16 screws
total) prior to moving to the next assembly process.
Photo 11