Harmonic Resolution Systems MXR Audio Stand - Manual (Page 12)

When the proper location has been achieved, torque all 32 of the 1/4-20 x 3/4"
screws at the panel block locations (see Photo 20) and the 16 1/4-20 x 1" screws in
the center of the two brace sub assemblies (see Photo 19). All of the screws should
be very securely tightened by hand. With the wrenches provided you should apply
maximum hand tightening force without straining yourself. Do not use any
extension or large wrenches that could over torque and strip the threads.
Photo 19 Photo 20
Installation of Remaining Adjustable Foot System - Unwrap the other two feet
supplied with the unit. Remove the screw and washer from each of the feet (see
Photo 21). Once the washer is removed, hand tighten the nut all the way down on
each individual foot. Then back the nut off one-half of a rotation on each foot (see
Photo 22).
Photo 21 Photo 22
Place the supplied washer on top of the nut and then screw each of the feet into the
threaded inserts on the bottom of the second panel (see Photo 23 & 24). The feet
should be threaded into the insert until the washer/nut come in contact with the
vertical panel threaded insert (insures maximum engagement between the insert
and the foot). Repeat this procedure and install the second foot to the bottom of the
second vertical panel.