Harmonic Resolution Systems MXR Audio Stand - Manual (Page 7)

vertical panel threaded insert. (This ensures maximum engagement between the
insert and the foot). Repeat this procedure and install the second foot to the bottom
of the first vertical panel.
Photo 5 Photo 6
Panel Brace Installation - You are now ready to attach the primary brace system
to the panel. There are two braces that hold the two end panels together to form
the primary MXR Frame Structure. There are two rectangular spacers attached to
each brace system when it is shipped that need to be loosened to complete
assembly. Simply take the T-wrench or Allen wrench supplied with the MXR and
loosen (counter clockwise) each of the eight nuts on the brace assembly (see Photo
7). You do not want to have lots of play in the assembly, you just want to break the
torque on each nut so that the brace can be properly located.
Photo 7
The HRS logo is machined into the center of each brace. Locate the HRS logo on
the brace and orient it so that when the stand is upright on its feet, the logo will be
in correct orientation. There are two steps at each end of the brace sub assembly
that fit precisely over the attachment block on the panel. Slowly lower the brace
assembly onto the block until the steps in the brace contact the block (see Photo 8
and Photo 9). Attach at least one of the 1/4-20 x 3/4" screws to the brace assembly
(see Photo 10) prior to removing your hand from the assembly to insure it stays in
place. It is very important that the 3/4" long screws are used at this location to
obtain proper thread engagement.