Konig Electronic Digital video recorder with built-in 1 TB hard disk - Manual (Page 11)

ENGLISH
11
Chapter 3: DVR CONNECTION
3�1 HDD Installation
Caution: Please do not Install or take out hard drive when DVR is running!
HDD Installation:
(1) Cut power firstly, and then remove screws and open DVR upper cover carefully;
(2) Insert Power Cord and data cable into Pin of hard drive securely;
(3) Remove the screws on the HDD bracket; fix the HDD to the bracket and then fix the bracket
with HDD to DVR body;
(4) Put the upper cover back carefully, re-attach screws.
Note: If user requires higher performance HDD, strongly recommend you use special hard
driver for security and protection.
3�2 Camera and Monitor Connection
Connect camera cable to video input of DVR, and from video output of DVR to Monitor via
BNC connector (Refer to section2.2-Rear Panel); or
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of
DVR respectively (refer to system figuration on Chapter 8).
3�3 Power Supply connection
After power on please make sure the video I/O connection well, audio device with BNC cable.
Chapter 4: DVR Boot up
4�1 System Initialization
Picture 4-1
After connecting the Power cable of DVR to wall
outlet and pressing the Power button on the front
panel, you will enter into the system initializing
screen shown as Picture 4-1.