Konig Electronic Digital video recorder with built-in 1 TB hard disk - Manual (Page 31)

ENGLISH
31
¾ Auto-overwrite: When set to ENABLE the DVR will record over the oldest files on the
hard drive. The DVR will always be able to record events as they happen, however, it does
means that you’ll need to get important events off the HDD before they’re overwritten;
and if overwrite is set to DISABLE the DVR will stop record once the DVR is full. Whilst you
won’t lose old footage, you run the risk of missing new events as they happen. Be sure you
want to do this before selecting it.
¾ HDD Format: Formatting the HDD will erase all data (i.e. footage) which is stored on it, and
re-create the FAT (file allocation table).
¾ USB Format: If you have a USB flash drive connected to the DVR, you can format that, too.
To do this, click the [USB Format] button and click [OK].
Note: It is an important first step when configuring your DVR to make sure that the hard drive
(HDD) options are correctly set. So, strongly suggest that you do format the HDD before start
the first record.
5�2�6�2 PTZ Set
Click [Main MenuDevicePTZ] to enter into the below window shown as Picture 5-47.
Picture 5-47
You could select the channel you desire to control
and set PTZ protocol (Pelco-D or Pelco-P), Baud Rate
(1200, 2400, 4800, 9600), Data bit (8, 7, 6, 5), Stop bit
(1, 2), Parity Check (None, Odd, Even, Mark, Space),
Address Code and Cruise status respectively. Please
note the PTZ device can be activated only when
a channel in connection with the PTZ camera is
selected.
5�2�6�3 Serial Set
Enter into the [Main menuDeviceSerial Set] interface shown as Picture 5-48.
Picture 5-48
When operate DVR via keyboard, it is required to set
communication protocol.
¾ Baud rate: set baud rate of serial communication.
¾ Data bit: set data bit of serial communication.
¾ Stop bit: set stop bit.
¾ Parity Check: set parity check to <None> or other.