Konig Electronic Digital video recorder with built-in 1 TB hard disk - Manual (Page 29)

ENGLISH
29
¾ Buzzer time: you can set how long the buzzer will sound when motion is detected (off,
10s, 30s, 40s, 60s).
¾ Send Email: Allows you set the alarm images is issued to a specified email.
¾ Full screen Alarm: The function is defaulted to “On”. When the motion is detected, the
corresponding channel will be switched to the full screen mode.
¾ Record Channel: the record channel will be activated when the object move is detected.
¾ Post Recording: you can set how long alarm record will last when alarm ends
(30s, 1minutes, 2minutes, 5minutes).
¾ Copy: allow you copy current channel parameters to any other channel or all channels.
Picture 5-43
The channel will be separated into a 44x36 grids
(PAL/NTSC mode). When any object moves into the
motion detection area, and the area where the object
is located is displayed in red and motion detection
will be triggered. In the semi-transparent area the
motion detection is not activated.
After configuring the above parameters, click <OK>
to save it.
5�2�5�2 Alarm Set
Click [Main MenuAlarmAlarm] to enter into the below window shown as Picture 5-44.
Now you can perform alarm set based on different status. Details please refer to List 5-1
Picture 5-44
¾ No: allow you select one desired channel
¾ I/O Status: allows you select the three options
– NO (Normal Open), NC (Normal Close) and
OFF. Set to “Normal Open”, I/O status Alarm will
be activated while sensor is ON; set to “Normal
Close”, I/O status alarm will be activated while
sensor is OFF; set to “OFF”, I/O status alarm will
not be triggered.
¾ Alarm out: allow you connect external alarm
sensor.
¾ Latch time: you can set how long the buzzer will sound when external sensor alarm is
detected (10s, 20s, 40s, 60s).
¾ Show Message: You can set show message on the screen when sensor alarm is detected.
¾ Buzzer time: you can set how long the buzzer will sound when sensor alarm is detected
(Off, 10s, 20s, 40s, 60s).
¾ Send Email: Allows you set the alarm images is issued to a specified email.
¾ Full screen Alarm: The function is defaulted to “On”. When the motion detection or
external alarm is triggered, the corresponding channel will be switched to the full screen
mode.