Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 11)

Page 10
5. Using a small flat head screw driver, un-
clip each snap fitting retainer on the hydraulic
prop rods. With the clip pulled out, remove the
prop rod from the snap fitting by pulling it away
from the hood. There is one per side of the hood.
You will need the help of an assistant to hold up
the hood.
6. Using a 13mm socket and ratchet, remove
the four (4) nuts holding the hood hinge to the
engine bay frame. There are two (2) on each side
of the vehicle. Then, with the help of an assistant,
lift the hood away from the car and place it on the
clean surface set up in step 2.
7. Raise the vehicle with a vehicle hoist or a
jack and jackstands. Be careful to follow
the GM lifting procedures on the C5 Corvette
due to the aerodynamic components being
easily damaged and the low ride height of the
vehicle.
8. After placing jack stands under the vehicle,
place a catch pan under the radiator and remove
the coolant reservoir cap. Then using a 1/4”
ratchet and extension, open the coolant drain
valve and allow the coolant to drain completely.
The following step shows the coolant drain valve.
NOTE: Save the coolant to reuse after the
installation is complete or dispose of the coolant
in a proper manner.