Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 24)

Page 23
56. Using teflon sealant, install the oil
pressure sensor into the new adaptor fitting
(which consists of an oil pressure relocation
fitting (PN: XX04468-0001), M16 X 1.5 Banjo
Bolt (PN: XX04468-0005), and two (2) banjo
bolt sealing washers (PN: 1501116). The yellow
arrow denotes where the oil pressure sensor is to
be installed in to the relocation fitting. Torque oil
pressure sensor to 15 ft-lbs.
57. Plug the oil pressure sensor assembly
back into the connector.
58. Using a 7/8” socket, screw in and tighten
the banjo bolt into the engine block. Torque the
bolt to 15 ft-lbs.
59. Using a rivet gun, install the supplied
coolant bleed plugs (PN: 12602048) in the two
(2) rear water line manifold holes. This provides a
seal that is permanent and the clearance needed
for the supercharger.
CAUTION: Do not let the coolant bleed plugs fall
into the water line holes. They can be extremely
difficult to retrieve if dropped.