Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 35)

Page 34
99. Using a 16mm wrench, remove the power
steering line from the steering rack and cover
with a rag.
100. Using a 24mm socket and a breaker bar,
remove the crank dampener bolt. You may need
to use a pipe over the breaker bar or impact
wrench for increased leverage.
101. Use a 24mm socket and wrench to install
the reamer guide and supplied bolt. Torque the
bolt to 37 ft-lbs. There are now two (2) holes in
the reamer guide. One will be used to drill out
the hole in step 103, while the other will be used
to ream the same hole in step 104. Refer to the
Edelbrock Installation hardware idenification
guide for a close-up view of the reamer guide
(refered to as the crank pinning drill guide in the
Edelbrock Installation instructions).
102. Using electrical or masking tape, mark off
the proper depth on the drill bit, which is to be
1.5” from the drilling tip.