Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 User Manual
Page 55
Page 54
178. Using a 10mm socket, ratchet, and
extension, remove the four (4) bolts holding the
top radiator shroud in place. They are located in
the front of the driver and passenger sides of the
engine bay.
179. Using a pry tool (or equivalent), remove
the two (2) radiator shroud clips located on the
top side of the radiator shroud on each side. Take
care not to break these clips as they will be re-
used later in the installation process.
180. Carefully pull straight up on the radiator
shroud and remove it from the vehicle.
181. Label the templates as passenger side
or driver side, then cut them out along the lines.
Using the supplied templates, hold onto the
inside of the shroud and mark the mounting holes
for the heat exchanger. Make sure you are using
the proper template for each side of the radiator
shroud.