Luxul XBR-4400 - Manual (Page 44)

Information on this document supersedes all previous versions. Products and documents subject to
change without notice. Products may be discontinued without notice.
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XBR-4400 Vers: 07314
© 2014 Luxul. All Rights Reserved.
APPENDIX 1: COMMON COMMANDS
Common Commands Description
Cmd
Enter the command line mode of a Windows system (applicable to
Windows2000 and higher).
ipconfig Displays the IP address of the computer. (i.e. ipconfig/all) Must be run
from the command line.
Ping Used to test for network availability and device/system recognition.
Device sends a packet to the target host and asks for a response. If
the device receives a response from the target host, it can then see
the network response time and connection status between the local
device and target host. Must be run from the command line.
netstat Displays details of current active network connections including
routing table and network interface information. Can also be used
to count the active network connections. Must be run from the
command line.
Tracert Displays the path taken by a packet before reaching the target host
and the specific time when it reached each node. Similar to the Ping
command but provides more detailed information. Displays the entire
path and IP address of each node in the path and total elapsed tim.
Must be run from the command line.