Draytek 2130 - Manual (Page 108)

Vigor2130 Series User’s Guide 100
4 4 . . 1 1 . . 2 2 P P o o r r t t s s
Ports page is used to change the setting for WAN port. You can set or reset the following
items. All of them are described in detail below.
Port It displays current network interface.
Link It displays current connection status. Green light means the
WAN connection is successful.
Current It displays current speed that the router uses.
Speed Configured You can use the drop down list to choose the required speed for
the router. If you have no idea in configuring speed, simple use
the default setting, Auto.
Flow Control If flow control is enabled by checking Configured box, both
parties can send PAUSE frame to the transmitting device(s) if
the receiving port is too busy to handle. If not, there will be no
flow control in the port. It drops the packet if too much to
handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
Current Tx: indicates whether pause frames on the port are
transmitted.
Maximum Frame This module offers 1518~9600 (Bytes) length to make the long
packet for data transmission.
Excessive Collision Mode There are two modes for you to choose when excessive
collision happened in half-duplex condition.