8 data flow monitor – Draytek 2130 User Manual
Page 199
Vigor2130 Series User’s Guide
191
4
4
.
.
1
1
2
2
.
.
8
8
D
D
a
a
t
t
a
a
F
F
l
l
o
o
w
w
M
M
o
o
n
n
i
i
t
t
o
o
r
r
This page displays the running procedure for the IP address monitored and refreshes the data
in an interval of several seconds. The IP address listed here is configured in Bandwidth
Management. You have to enable IP bandwidth limit and IP session limit before invoke Data
Flow Monitor. If not, a notification dialog box will appear to remind you enabling it.
Click Diagnostics and click Data Flow Monitor to open the web page. You can click IP
Address, TX rate, RX rate or Session link for arranging the data display.
Auto-refresh
Check it to enable auto-refresh function.
Refresh
Click this link to refresh this page manually.
Index
Display the number of the data flow.
IP Address
Display the IP address of the monitored device.
TX rate (kbps)
Display the transmission speed of the monitored device.
If "HNAT" is shown, that means the transmission is
through Hardware NAT can't be computed.
RX rate (kbps)
Display the receiving speed of the monitored device.
If "HNAT" is shown, that means the transmission is
through Hardware NAT can't be computed.
Sessions
Display the session number that you specified in Limit
Session web page.
Action
Block - can prevent specified PC accessing into Internet
within 5 minutes.