Rocktron Intellifex On-Line User Manual
Page 46
43
This entire process is repeated 7 times for a total of 8 controllers (NUMB2, NUMB3,
etc.). To exit Controller Assign at any time, turn the PRESET or FUNCTION SELECT
controls. Only those changes that have been stored will be saved after exiting Control-
ler Assign.
Also, a lower limit may be selected which is greater than the upper limit. This will invert
the response of the controller. For example, the toe position of an expression pedal
would provide the minimum value while the heel position would provide the maximum
value.
Notes
Step 11
Turn the PARAMETER SELECT control for the last parameter - Controller Lower Limit.
LLIM C1
XXX
Step 12
Use the PARAMETER ADJUST control to select the parameter value which the controller
is not to fall below.
LLIM C1
-10.0
After choosing a lower limit parameter value, press the STORE button to save it.
"STORED" will flash briefly on the display.
Step 13
STORED