Rocktron Intellifex On-Line - Manual (Page 54)

51
Reloading the user memory from a sequencer:
Connect the MIDI OUT of the sequencer to the MIDI IN on the Intellifex Online with a
standard MIDI cable. Step 1
Turn the FUNCTION SELECT control on the Intellifex Online fully clockwise to the "MIDI
DUMP/LOAD" position. Step 2
MIDI DUMP LOAD
Turn the PARAMETER SELECT control to the "LOAD USER DATA" position. The
Intellifex Online is now ready to receive the user data from the sequencer. Step 3
LOAD USER DATA
Play back the user data previously recorded on the sequencer. The Intellifex Online will
display the data strings as it is storing them. The data string and "LOADED" will appear on
the display. After all the user data has been loaded the Intellifex Online will display "USER
DATA LOADED". The entire procedure will take approximately 3 minutes to complete. Step 4
USER DATA LOADED
Do not play back data from the sequencer faster than it was recorded, as errors may
occur. Errors may also occur if any knob is turned or any button is pressed before the
message “USER DATA LOADED”appears.