Rocktron Intellifex On-Line - Manual (Page 6)

3
Some of the controls on the Intellifex Online front panel have more than one function,
dependent upon what mode the unit is currently operating in. Please read this section to become
better aquainted with these functions.
1 POWER switch
2 RECALL button:
This button is used to recall the displayed preset.
3 PRESET control:
The function of this control is dependent on the CONFIG button.
When the CONFIG LED is off, turning the PRESET control will cause the Intellifex Online to
exit its current function. The PRESET control may then be used to scroll through the
successive factory and user presets and titles stored in its memory.
When the CONFIG LED is on, the PRESET control is again used to scroll through the
successive presets, but instead of displaying preset titles the Intellifex Online will display the
effect configuration stored for each preset.
4 CONFIG button:
The CONFIG button is used to toggle between displaying either the preset title or the
configuration of the currently displayed preset. The configuration display indicates both
which effects the displayed preset executes and the order in which they are executed. The
LED above the CONFIG button is lit when the configuration is displayed.
5 DISPLAY panel:
The DISPLAY panel is a 16 character, vacuum fluorescent display type.
6 COMPARE button:
The COMPARE button may be used to compare a modified parameter value to its stored
value. (If comparing an altered value to the stored value and the stored value is currently
being viewed, turning a knob or pressing a button that changes the parameter value
displayed will cancel the previous modified value.)
The COMPARE button may also be used to simultaneously compare multiple modified
parameters under the same effect heading (i.e. Reverb, Mixer, etc.) to the stored values. To do
so, turn to the effect heading where the modified parameters are located and press the
COMPARE button. When the STORE LED is off, the stored parameter values are currently
active. When the STORE LED is lit, the modifed values are active.
If a knob is turned or a button is pressed which changes the effect heading when the stored
parameters are active (STORE LED off), any modified parameter values under that heading
will be lost. This is also true if a MIDI control change is received while the stored parameters
are active.
3. Front Panel