Rocktron Intellifex On-Line - Manual (Page 7)

4
7 PARAMETER ADJUST control:
This control is used to adjust the displayed parameter value. When the parameter is changed
from its original value, the LED above the STORE button will light until either (a) the new
value is stored, (b) a new preset is selected or (c) the parameter is returned to its original
value.
8 STORE button:
This button is used to store values into the Intellifex Online memory when modified. See
Chapter 8, section C, "Storing Modified Parameters" for more information.
9 PARAMETER SELECT control:
When monitoring parameter values, this control will scroll through the available parameters
under the current effect heading.
In the "TITLE EDlT" function, this control will scroll through the available characters in the
title that may be edited.
10 FUNCTION SELECT control:
This control allows access to each function of the Intellifex Online. Depending on which
configuration the current preset is built upon, these functions may include:
Preset Select Reverb Parameters
Mixer Parameters Title Edit
HUSH Parameters MIDI Controller Mapping
Chorus Parameters MIDI Program Mapping
Pitch Shift Parameters MIDI Channel
Delay Parameters Ducker Parameters
Factory Restore MIDI Dump/Load
11 BYPASS button:
When pressed, the LED is lit and all effects are bypassed.
12 INPUT LEVEL meter:
These LEDs provide visual indication of the peak level of the input signal. For the optimal
signal-to-noise ratio, it is best to adjust the input level so that the last LED (0dB) is rarely lit.
This will guard against the possibility of overdriving the unit.
13 INPUT LEVEL control:
This control adjusts the unit's gain to match the signal level at the input of the Intellifex
Online. The gain can be adjusted from -12dB to +12dB. Use the INPUT LEVEL meter to
determine the setting of this control.
14 CLIP L.E.D.:
This L.E.D. is part of the output section and, when lit, indicates that the final analog output is
being overdriven because the Effects Level, Direct level, and Output Level control are set too
high. If this occurs, reduce these levels until this L.E.D. does not light.
15 OUTPUT LEVEL control:
This control is used to adjust the output level of the unit and may be adjusted from zero
signal to a small amount of gain.
16 REFERENCE LEVEL switch:
This switch determines the output range of the unit and may be set at either -10dB or +4dB.
When using professional studio equipment providing a nominal input level of +4dB, it is
recommended that the +4 setting on the Intellifex Online be used for best results. If
connecting the Intellifex Online to a high sensitivity input, such as the input to a guitar amp,
the -10 setting should be used.