Xblue Networks X-44 - Manual (Page 74)

Language Setting
• System Language - English is the only language that is supported currently.
Volume Control
There are 7 different volume levels that can be customized, on the fly, by the user. Each parameter has
10 different volume levels to choose from.
• Handset Mic: - Select the proper volume, between 1 and 10. One (1) being the lowest and ten (10)
being the highest volume. The Handset Mic is set to 5 at default.
• Handset Speaker: - Select the proper volume, between 0 and 9. Zero (0) being the lowest and nine
(9) being the highest volume. The Handset Speaker is set to 4 at default.
• Ring Volume: - Select the proper volume, between 0 and 9. Zero (0) being the lowest and nine (9)
being the highest volume. The Ring Volume is set to 4 at default.
• Handsfree Mic: - Select the proper volume, between 1 and 10. One (1) being the lowest and ten
(10) being the highest volume. The Handsfree Mic is set to 5 at default.
• Handsfree Speaker: - Select the proper volume, between 0 and 0. Zero (0) being the lowest and
nine (9) being the highest volume. The Handsfree Speaker is set to 4 at default.
• Headset Mic: - Select the proper volume, between 1 and 10. One (1) being the lowest and ten (10)
being the highest volume. The Headset Mic is set to 5 at default.
• Headset Speaker: - Select the proper volume, between 0 and 9. Zero (0) being the lowest and nine
(9) being the highest volume. The Headset Speaker is set to 4 at default.
Tone/Ring Selection
• Tone Type - Select the Country where the telephone will be installed. The default settings is “United
States”.
• Ring Type - Personalize the ring tone by selecting one of eleven (11) different ring tones. Select
between zero (0), the default, and ten (10).
Voice Parameters
• Echo Canceller: - Check to enable “Echo Cancellation” which will eliminate unwanted echo.
• VAD+CNG: - Check to enable “Voice Activity Detection (VAD)” and “Comfort Noise Generation
(CNG)”.
Phone Features
• Auto Answer: - Check to enable “Auto Answer”, which will automatically answer any (Intercom or
Telephone Line) calls that are programmed to ring at your extension.
• DND: - Check this parameter to place the telephone into Do Not Disturb. If the “DND Forwarding”
is enabled, calls to your telephone will be sent directly to voice mail. If not, the call will not transfer.
• CLIP: - Check this parameter to enable “Calling Line Identity Presence (CLIP)”. When enabled the
Caller ID of incoming calls will show on your telephones LCD Display.
• CLIR: -
• Call Waiting: - Check to enable “Call Waiting”, which allows your telephone to receive a second
telephone call, when you are busy on a call.
• Call Waiting Tone: - Check this parameter to enable the “Call Waiting Tone”, which is heard when
call waiting is enabled and a second call is programmed to ring on your extension.
• Hold Reminder: - Check this parameter to enable “Hold Reminder” which will remind you, with a
single tone burst, each time the Hold Reminder Time Expires.
• Hold Reminder Time (sec): - Select how often, in seconds from zero (0) never to sixty (60)
seconds, which is how often the hold reminder tone should play.
Web Programming
74