Xblue Networks X-44 - Manual (Page 88)

• Session Expires (sec) - This is the maximum amount of time, in seconds, that an X-44 telephone
can go without synchronizing with all other telephones. If this time elapses and the phone does not
communicate, the phone is considered off line.
• Min-SE (sec) - This is the minimum amount of time, in seconds, that an X-44 telephone can go
before it synchronizes with all other X-44 telephones on your network.
Auto Provision Settings
• When enabled, the X-44 will go to a specific SIP Trunk provider and automatically download all of
the information needed to setup and start using your SIP Trunks. Only enable this parameter once
you have decided which SIP Trunk provider you will be using.
All Paging Access Code
• The default All Paging Access Code is set to *99, which will open a one way page to any idle
telephone on your network, allowing the user to make an announcement.
Operator Setting
• Operator - Is the extension that will ring when someone dials zero.
Operating Mode
The X-44 can be set to Day only, Night only or to automatically switch between day and night. When
set to Day - only the day greeting will play; when set to night only the night greeting will play; when set
to time mode, the day greeting will play between the hours entered into the working hours schedule, and
after that, the night greeting will play. The hours are set in 24 hour format. An entry of 08:30 to 17:00,
means means that you open at 8:30 am and close at 5:00 pm.
• Operating Mode - Using the drop down menu select between Day - Night and Time Modes
• Working Hours - Enter the start and end time for each day of the week. An entry of all zeros,
means that the message will not change for the currently playing message.
NAT Settings
• Enable STUN - Session Traversal Utilities for NAT - This parameter is used to make a specific device
on an internal Local Area Network, to appear as a device on the Internet. Consequently, this
parameter is not commonly used. not be
• STUN Server - Enter the IP Address of the STUN Server
• STUN Server Port - Enter the port that the STUN Server will use to communicate.
Programming Menu
88