Setting preset ptys (rds only), Rds messages – Pontiac 2005 Grand Prix User Manual

Page 214

Advertising
background image

w

SCAN

x

: Scan the stations within a PTY by

performing the following:

1. Press PROG TYPE to activate program type select

mode. The PTY symbol will appear on the display.

2. Turn the SELECT knob to select a PTY.

3. Once the desired PTY is displayed, press and hold

either SCAN arrow, and the radio will begin
scanning the stations in the PTY.

4. Press either SCAN arrow to stop at a station.

If both PTY and TRAF are on, the radio will scan for
stations with the selected PTY and traffic
announcements.

BAND (Alternate Frequency): Alternate frequency
allows the radio to switch to a stronger station with the
same program type. To turn alternate frequency on,
press and hold BAND for two seconds. AF ON will
appear on the display. The radio may switch to stations
with a stronger frequency.

To turn alternate frequency off, press and hold BAND
again for two seconds. AF OFF will appear on the
display. The radio will not switch to other stations.

This function does not apply for XM™ Satellite Radio
Service.

Setting Preset PTYs (RDS Only)

These pushbuttons have factory PTY presets. Up to
12 PTYs (six FM1 and six FM2), can be programmed on
the six numbered pushbuttons, by performing the
following steps:

1. Press BAND to select FM1 or FM2.

2. Press PROG TYPE to activate program type select

mode. The PTY symbol will appear on the display.

3. Turn the SELECT knob to select a PTY.

4. Press and hold one of the six numbered

pushbuttons until you hear a beep. Whenever that
numbered pushbutton is pressed, the PTY that
was set will return, if program type select mode is
activated.

5. Repeat the steps for each pushbutton.

RDS Messages

ALERT!: Alert warns of local or national emergencies.
When an alert announcement comes on the current
radio station, ALERT! will appear on the display. You will
hear the announcement, even if the volume is low or
a CD is playing. If a CD is playing, play will stop during
the announcement. Alert announcements cannot be
turned off.

ALERT! will not be affected by tests of the emergency
broadcast system. This feature is not supported by
all RDS stations.

3-108

Advertising