Pontiac 2005 Grand Prix - Manual (Page 376)

Removing Bolt-On Wheel Covers with
Center Caps on Steel Wheels
If the vehicle has steel wheel covers with center caps,
the wheel nuts are behind the caps. To remove, do
the following:
1. Pry off the center caps by inserting the flat end of
the wheel wrench at the notch on the cap.
2. Use the wheel wrench to loosen the plastic wheel
nut caps in a counterclockwise direction. If needed,
finish loosening them by hand. The nut caps will
not come off.
3. Use the flat end of the wheel wrench and pry along
the edge of the cover until it comes off.
The edge of the wheel cover could be sharp,
so do not try to remove the cover with bare hands.
Do not drop or lay the cover face down, as it
could become scratched or damaged.
Once you have removed the wheel cover, center cap,
or nut caps, use the following procedure to remove
the flat tire and install the spare tire.
1. Using the wheel wrench, loosen all the wheel nuts.
Do not remove them yet.
{ CAUTION:
Getting under a vehicle when it is jacked up is
dangerous. If the vehicle slips off the jack you
could be badly injured or killed. Never get under
a vehicle when it is supported only by a jack.
5-86