DMP Electronics Security Control Receiver SCS-1R - Manual (Page 32)

SCS-1R Installation Guide Digital Monitoring Products
27
OPERATOR’S GUIDE
ENTER DATE:
- / /
Date
Press any top row Select key to enter the date. Enter the month, date, and year in the
following format: MM/DD/YY, with leading zeroes. Press COMMAND to accept the date
and display the following prompt.
TIME CHANGED
Time/Date Changed
If the Time or Date has been changed successfully, the display shows TIME/DATE CHANGED.
Exit Programming Menu
Exit Menu allows you to properly end programming and exit the menu.
SCS-1R MENU
STOP
Exit Menu
Press any top row Select key to exit the SCS-1R menu.
Browser Programming
Programming of the SCS-150, version 103 or higher, can be performed using a browser.
Note: Obtain an IP and Gateway address from the network administrator. Enter the IP and Gateway address in
Receiver Options at the SCS-1R membrane keypad to allow access to browser programming for the first time.
The IP Address must be unique and cannot be duplicated. Make sure the network connection is secure and the
security on the network connection does not allow outside access to this site before accessing programming through
the browser.
After programming the IP and Gateway addresses in Receiver Options at the membrane keypad, cconnect to the SCS-
150 by entering the IP address into the address bar of any web browser. Once connected, the Authenticated Required
box displays.
When accessing the programming for the first time, the default User Name and Password are both “NEW”. Once in
the programming, the User
Name and Password should be
changed in Receiver Options.
Each SCS-150 programming
section in the browser is
independent and changes
should be saved after
programming is completed
for each section.
Receiver Options
This section assigns the company name and system number as well as the IP and Gateway addresses for each
SCS-1R Receiver incoming line.