Altera Cyclone V E FPGA - Manual (Page 25)

Chapter 6: Board Test System 6–9
Using the Board Test System
December 2014 Altera Corporation Cyclone V E FPGA Development Kit
User Guide
The SSRAM Tab
The SSRAM tab allows you to read and write SRAM and flash memory on your
board.
Figure 6–4 shows the SSRAM tab.
The following sections describe the controls on the SSRAM tab.
Read
The Read control reads the SRAM on your board. To see the SRAM contents, type a
starting address in the text box and click Read. Values starting at the specified address
appear in the table.
Write
The Write control writes the SRAM on your board. To update the SRAM contents,
change values in the table and click Write. The application writes the new values to
SRAM and then reads the values back to guarantee that the graphical display
accurately reflects the memory contents.
Figure 6–4. The SSRAM Tab