Power supply cable, Connecting the power supply cable – Altera DSP Development Kit, Cyclone II Edition Getting Started User Manual
Page 21
Advertising
Altera Corporation
Getting Started User Guide
2–11
August 2006
DSP Development Kit, Cyclone II Edition
Getting Started
Power Supply Cable
Connect the power cable to the Cyclone II DSP development board as
shown in
and plug the transformer end into a power outlet.
Figure 2–5. Connected Power Supply Cable
To power-up the Cyclone II DSP development board, place SW1 (POWER
switch) in the ON position. When power is supplied to the Cyclone II DSP
development board, LED D1 turns on, indicating the board has power.
Power Cable
J1
Power Connector
Advertising