Altera DSP Development Kit, Cyclone II Edition Getting Started - Manual (Page 27)

Altera Corporation Getting Started User Guide 2–17
August 2006 DSP Development Kit, Cyclone II Edition
Getting Started
Configuring the Board
To configure the Cyclone II DSP development board, follow these steps:
1. Connect the SLP-50 filter (low pass filter) to one end of the SMA
cable.
2. Use the cable-filter assembly to connect DAC CHANNEL A (J31)
with ADC CHANNEL A (J32).
3. Add the correct jumpers for the clocks (see Figure 2–8 and
Figure 2–9 ).
a. For the DAC CHANNEL A Clock Select (J35), place a jumper
on pins 1 and 2.
b. For the ADC CHANNEL A Clock Select (J37), place a jumper
on pins 1 and 2.
4. For the ADC Output Data Format Select (J30) place a jumper on pins
5 and 6. This sets the data output format to two’s complement.
f
For more information about the data output format from the ADC, refer
to the Analog-to-Digital Converter (U26) section in the Cyclone II DSP
Development Board Reference Manual.