User controls, Options | advanced – Optoma EH503 User Manual
Page 61
English
61
Options | Advanced
Direct Power On
Enable or disable Direct Power On.
4
On—the projector powers on automatically when AC power is supplied.
4
Off— the projector must be powered on as normal.
Signal Power On
Enable or disable Signal Power On.
4
On—the projector powers on automatically when an active signal is detected.
4
Off— disable the power on trigger by active signal is detected.
1. Only available on Standby Mode is Active.
2. If projector is turned off with keeping input the signal source (the last
image source showing on screen), it will not re-start unless:
a. Terminate the last image source and input any signal source again.
b. Unplug and re-plug the projector power again.
3. Signal power on will ignore “source lock” setting.
Auto Power Off (min)
Set the Auto Power Off interval. The projector powers off the lamp after
30 minutes of no signal by default. The following warning is displayed 60
seconds before power off.
User Controls