Optoma W350 - Manual (Page 14)

14
English
Installation

Contact the
nearest service
center if the
projector displays
these symptoms.
See pages
71-72 for more
information.
Powering off the projector
1. Press the “ ” button on the remote control or on the
control panel to turn off the projector.
The following message will be displayed on the screen.
Press the “ ” button again to confirm otherwise the
message will disappear after 15 seconds. The projector will
shut down when the “ ” button is pressed for the second
time.
2. The fans will continue to operate for 10 seconds and the
POWER LED will flash blue. During this period, the projec-
tor cannot be turned back on and the projector should not
be unplugged.
Once the cooling cycle is complete, the POWER LED will
turn to solid red (standby mode). At this point, the projector
can be turned back on by pushing the “ ” button.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.
Warning Indicator
When the warning indicators (see below) come on, the
projector will automatically shutdown:
 “LAMP” LED indicator is lit red and if “On/Standby” indica-
tor flashes red.
 “TEMP” LED indicator is lit red and if “On/Standby”
indicator flashes red. This indicates the projector has
overheated. Under normal conditions, the projector can be
switched back on.
 “TEMP” LED indicator flashes red and if “On/Standby”
indicator flashes red.
Unplug the power cord from the projector, wait for 30 seconds
and try again. If the warning indicator light up again, please
contact your nearest service center for assistance.