Atlona AT VGA MATRIX - Manual (Page 13)

Atlona Technologies www.atlona.com 13
Note: This command does not need follow by “END” & “ENTER”
Example2: To transfer all input signals to the corresponding output channels
In another word, to switch to this status: 1->1, 2->2, 3->3, 4->4……16->16.
Operation: Press buttons in the following order “ALL”, “1”
Example3: To switch off all the output channels
Operation: Press buttons in the following order “ALL”, “2”
“SAVE” Save button: To save the present operation to a preset command
Example: To save the present operation to the preset command No.2
Operation: Press buttons in the following order “SAVE”, “2”
Note: There are altogether 10 preset commands ranged from No.0 to No.10.
“RECALL” Recall button: To recall the preset command
Example: To recall the preset command No.2
Operation: Press buttons in the following order “RECALL”, “2”
“CANCEL” Cancel button: To return to the standby status without performing any commands
Example: To cancel the input instructions “1”, “AV”, “2”, “END”
Operation: Just press button“CANCEL” after the above inputs
“STATUS” Acquire status button: To Acquire the present status
Example1: To Acquire the status of output channel No.7
Operation: Press buttons in the following order “7”, “STATUS”
Example2: To Acquire the status of all the output channels one by one
Operation: Press only the button “STATUS”
With the front control panel, the switcher could be control directly and rapidly by pressing the
button under below format.
“Input Channel”+“Switching Mode”+“Output Channel 1”+“/”+“Output Channel
2”+“END”+“ENTER”