KLING & FREITAG K&F ACCESS T9 - Manual (Page 42)

User’s Manual ACCESS SYSTEM
KLING & FREITAG GMBH ©1995-2009 Version 6.0, 17.03.2009 Page 42 of 60
12.2 Using the MAN Rigging Points
Eyebolt MAN installation stud.
To be used with fixed installations.
No No No No
additional speakers may by su additional speakers may by su additional speakers may by su additional speakers may by sus- s- s- s-
pended from the eyebolt MAN i pended from the eyebolt MAN i pended from the eyebolt MAN i pended from the eyebolt MAN in- n- n- n-
stallation stud. stallation stud. stallation stud. stallation stud.
Eye bolt MAN stud plate (HWSP)
To be used with mobile installations.
1.) 1.)
Loosen all but the last two threads of
the stud’s nut. Put the eyebolt in the
speaker’s receptacle so that the tip of
the nut points down. Pull up the eyebolt’s locking device
with the thumb and index finger
and put the eyebolt into the
speaker’s receptacle.
2.) 2.)
Pull up the eyebolt and screw it in
tightly. Then loosen the eyebolt by
maximal ½ turn so that it cannot be
tightened all the way when the
speaker is tilted. Pull up the eyebolt while pulling on
the locking device. Then let go of
the locking device.
3.) 3.)
Make sure that the eyebolt is stable
and that it cannot be pulled down. Make sure that the eyebolt is stable
and that it cannot be pulled down.
4.)
When using chains, make sure that the
openings of the hooks are always
turned toward the front side of the
speaker.
Warning