One Systems PT-10 User Manual
Page 11
One Systems, Inc. 6204 Gardendale Dr., Nashville, TN 37215
11
4. The loudspeaker may now be placed on the pole bracket.
USE EXTREME CAUTION! The loudspeaker is heavy and it is likely that the desired
mounting location is high in the air. This process should never be attempted by a single
person.
TWO OR MORE PEOPLE ARE REQUIRED TO MOUNT THE LOUDSPEAKER
ENCLOSURE TO THE WALL OR POLE AND PT bracket. Safety harnesses should
always be worn when working from an elevated platform.
The PT-76a mounts to the rear of ALL IM series enclosures, except for the 108IM,
108CIM and 208CIM, using the 140mm x 90mm M10 locations as shown in figure 2c.
The PT-38 mounts to the top or bottom or top of the 108IM, 108CIM or 208CIM as
shown in figure 2c using the M8 locations. The mounting locations are highlighted in red.
(SEE IMPORTANT NOTE REGARDING THE M10 FLAT WASHERS AND THE PT-76a
BELOW)
DO NOT SUBSTITUTE MOUNTING LOCATIONS!
NOTE: There are 8 each hex head M10 bolts supplied in the mounting kit of the PT-76.
When mounting the 115TW (wood) enclosures to the PT-76 use 4 each of the 45mm
(longer) M10 bolts. The 4 shorter M10 bolts are used for the IM series injection molded
enclosures and the CFA enclosures.
NOTE: There are M10 flat washers in the PT-76a kit. DO NOT USE THESE WASHERS
FOR MOUNTING THE 112IM, 212CIM, 212IM, 312CIM or 115TW! The M10 flat
washers are for use with the CFA and CFA-2 ONLY! (See the image below, DO NOT
use flat washers under the M10 bolts used to mount the 112IM212CIM,312CIM,or
115TW.)