One Systems PT-10 User Manual
Page 7
One Systems, Inc. 6204 Gardendale Dr., Nashville, TN 37215
7
NOTE: The supplied gasket must be mounted to this surface of the PT-76a PRIOR to
attaching this part to the rear of the 112IM, 212CIM, 212IM or 312CIM enclosure!
Figure 2b PT-76 speaker mount bracket
The PT-76a mounts to the rear of ALL IM series enclosures, except for the 108IM and
208CIM, using the 140mm x 90mm M10 locations as shown in figure 2c. The PT-38a
mounts to the top or bottom or top of the 108IM or 208CIM as shown in figure 2c using
the M8 locations. The mounting locations are highlighted in red.
(SEE IMPORTANT
NOTE REGARDING THE M10 FLAT WASHERS AND THE PT-76a BELOW)
DO NOT SUBSTITUTE MOUNTING LOCATIONS!
NOTE: There are 8 each hex head M10 bolts supplied in the mounting kit of the PT-76a.
When mounting the 115TW (wood) enclosures to the PT-76 use 4 each of the 45mm
(longer) M10 bolts. The 4 shorter M10 bolts are used for the IM series injection molded
enclosures and the CFA enclosures.
NOTE: There are M10 flat washers in the PT-76a kit. DO NOT USE THESE WASHERS
FOR MOUNTING THE 112IM, 212CIM, 212IM ,or 312CIM! The M10 flat washers are
for use with the CFA and CFA-2 ONLY! (See the image below, DO NOT use flat
washers under the M10 bolts used to mount the 112IM, 212CIM, 212IM, or 312CIM.)