One Systems PT-10 User Manual
Page 21
One Systems, Inc. 6204 Gardendale Dr., Nashville, TN 37215
21
NOTE: Instructions for mounting the Band-It bands are supplied by Band-It
The PT-30 has three slots for mounting the back bracket assembly on a pole. ALL
THREE slots MUST be used. Each slot MUST be DOUBLE WRAPPED (two
INDEPENDENT bands per slot!) using the specified Band-It straps ONLY! DO NOT
substitute any other straps. IT IS NECESSARY TO USE ALL MOUNTING SLOTS TO
INSURE A SAFE AND SECURE MATE TO THE ASSOCIATED SURFACE!
IT IS CRITICAL THAT THE MATING SURFACE (Pole) BE CAPABLE OF
SUPPORTING THE LOAD OF THE PT-30 BRACKET, THE LOUDSPEAKER AND ALL
SUSPENSION HARDWARE, AS WELL AS PROVIDING THE PROPER SAFETY
FACTORS. DO NOT ATTEMPT TO SUSPEND THE BRACKET AND LOUDSPEAKER
UNTIL THE STRUCTURAL CHARACTERISTICS OF THE MATING SURFACE (Pole)
ARE UNDERSTOOD. DO NOT INSTALL THE PT BRACKET AND LOUDSPEAKER IF
THE MATING SURFACE (Pole) IS NOT CAPABLE OF SUPPORTING THE ENTIRE
ASSEMBLY WEIGHT, AS WELL AS PROVIDING THE REQUIRED SAFETY
FACTORS!
IMPORTANT: There are 3 slots indicated by the red arrows in the image below. Each of
the 3 slots must be utilized to insure a secure mount to a pole. ALL 3 slots must use
double wrapped bands (Two independent bands wrapped in each slot)! The image
below shows the PT-30 mount to a round pole. As shown, ALL three band slots must be
used and all locations MUST be double wrapped (two independent band assemblies per
slot!)
The red arrows indicate the 3 slots used to band the PT-30 to a pole structure