Paxton Superchargers Denali - Manual (Page 17)

3-1
P/N: 4809639
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v3.0(01-03Denali/Esc(4809639v3.0))
Section 3
SUPERCHARGER MOUNTING BRACKET
A. Install the original alternator bushings into
the supercharger mounting bracket with
the flanged portion pointed back. (See
Figs. 3-a, 3-b.)
B. Clean front of driver’s side head of debris.
C. Bolt the supplied Paxton supercharger
mounting bracket to the head and block
using the original mounting bolts. Make
sure the mounting bracket is seated direct-
ly on a machined surface on the head and
that no wires are pinched.
D. Tighten the four mounting bolts to 37 ft-
lbs (50 N-m).
E. Install the two original bolts holding the
alternator fusible link junction box in the
supercharger mounting bracket so that it is
in the stock location.
F. Attach the power steering pump to the
Paxton bracket using the original mounting
hardware. Tighten the four power steering
pump bolts to 37 ft-lbs (50 N-m). (One
bolt is still loosely inserted in the engine
block.)
G. Reinstall the power steering pump pulley.
Make sure that it is seated flush with the
end of the power steering pump shaft.
H. Reinstall the alternator using the original
hardware. (See Fig. 3-c.)
I. Install the factory idler pulley at the loca-
tion shown in Fig. 5-b. Spin the idler to
verify that the rotating portion does not
contact the alternator bolt.
Fig. 3-a
Fig. 3-b
Fig. 3-c
3. SUPERCHARGER MOUNTING BRACKET