Paxton Superchargers Denali - Manual (Page 59)

22-1
P/N: 4809639
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v3.0(01-03Denali/Esc(4809639v3.0))
Section 22
FINAL ASSEMBLY AND CHECK
22. FINAL ASSEMBLY AND CHECK
A. Reconnect the battery.
B. If your vehicle has gone over 10,000 miles
since its last spark plug change, you will
need to change the spark plugs now before
test driving the vehicle.
C. Check all fittings, nuts, bolts and clamps
for tightness. Pay particular attention to oil
and fuel lines around moving parts, sharp
edges and exhaust system parts. Make sure
all wires and lines are properly secured
with clamps or tie wraps.
D. Check all fluid levels, making sure that
your tank(s) is/are filled with 91 octane or
higher fuel before commencing test drive.
E. The plastic engine cover that covers the
upper manifold will need to be modified in
order to reinstall. Refer to Fig. 22-b to trim
and reinstall.
F. Start engine and allow to idle a few min-
utes.
G. '02 Escalade: With the engine running,
check the brake booster line. Turn the
steering wheel in both directions.
Verify:
• Smooth power assist
• Noiseless operation
• Proper fluid level
• No system leaks
• No bubbles, foam or discoloration of
fluid
H. Recheck to be sure no hoses, wires, etc.
are near exhaust headers or moving parts
and check for any sign of fluid leakage.
Recheck all fluid levels.
I. PLEASE TAKE SPECIAL NOTE:
Operating the vehicle without ALL the
subassemblies completely and properly
installed may cause FAILURE OF
MAJOR COMPONENTS.
J. Test drive the vehicle.
K. Read the Street Supercharger System
Owner's Manual and RETURN THE
Warranty REGISTRATION FORM within
thirty (30) days of purchasing your super-
charger system to qualify for the 3 year
limited warranty.
Fig. 22-a
Fig. 22-b / Escalade shown