Paxton Superchargers 5.2 Dodge Ram - Manual (Page 11)

P/N: 4809625
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
25NOV03 v2.0 97-01 5.2/5.9 Dodge(4809625v2.0)
4-1
Fig. 4-c
Fig. 4-b
Section 4
SUPERCHARGER INSTALLATION AND ASSEMBLY
4-1 S/C MOUNTING BRACKET
A. Remove the pulley from the stock acces-
sory belt tensioner and the tensioner from
the stock bracket for re-installation.
B. This is how the bracket should look
before you install it. (See Fig. 4-a.) Note
the accessory belt tensioner bracket. This
spacer will have to be removed before you
install the bracket. The dipstick goes
between the tensioner and the spacer.
*** NOTE ***
The idler pulley and pulley stand off have been
removed
C. Mount the bracket in the holes at the stock
accessory belt tensioner location. Remove
the two countersunk allen head bolts and
lower this arm to gain access to the bolt
securing the dipstick. (See Fig. 4-b.)
*** NOTE ***
When installing spacer, you may have to bend the dip-
stick. Try not to bend it too much. The more you bend
it, the harder it is to get in and out.
D. Re-install countersunk bolts.
E. This is how the spacer should look
installed. Short portion toward the engine
block. (See Fig. 4-c.)
Fig. 4-a
REMOVE THIS SPACER
BEFORE INSTALLING
BRACKET
4-2 CRANK PULLEY ASSEMBLY
A. Remove the center retaining bolt using a
31mm socket. Also remove the six outer
bolts.