Paxton Superchargers 5.2 Dodge Ram - Manual (Page 7)

P/N: 4809625
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
25NOV03 v2.0 97-01 5.2/5.9 Dodge(4809625v2.0)
2-1
Fig. 2-a
Fig. 2-b
Fig. 2-c
Section 2
INITIAL PREPARATION AND DISASSEMBLY
Begin the initial preparation and disassembly
process by disconnecting the battery cables.
2-1 AIR INTAKE ASSEMBLY
A. Remove the nut from the top of the intake
bonnet and release clips holding the top of
the air box.
B. Remove plastic bonnet and air box cover
assembly. (See Fig. 2-a.)
C Remove plastic clip connecting air horn to
fender well. (See Fig. 2-b.)
D. Remove hardware, (two nuts and bolts)
holding air box to fender well and remove
airbox.
*** NOTE ***
You must remove air horn to gain access to one nut.
E. Remove factory bonnet hold down hard-
ware.
2-2 FAN AND FAN SHROUD REMOVAL
A. Start by removing fan clutch nut. (See Fig.
2-c.)
B. Remove four bolts holding fan shroud to
radiator.
C. Lift out fan shroud with fan and set aside.
(See Fig. 2-d.)
*** NOTE ***
You will have to modify the fan shroud before re-instal-
lation.
*** NOTE ***
Use factory tool or a 1 1/16 open-end wrench or a
large crescent wrench and a brass hammer.
Fig. 2-d