Paxton Superchargers 5.2 Dodge Ram - Manual (Page 14)

P/N: 4809625
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
25NOV03 v2.0 97-01 5.2/5.9 Dodge(4809625v2.0)
4-4
Fig. 4-o
NEW LOCATION
PLUG
NEW MTG
HARDWARE
Fig. 4-p
Fig. 4-l
Fig. 4-m
Fig. 4-n
4-9 AIR DISCHARGE
A. Replace the stock intake bonnet mounting
hardware with the bonnet adapter that is
provided. (See Fig. 4-p.)
E. Relocate the stock air temp sensor from
the intake manifold to the air intake duct.
Use the supplied pipe plug in place of the
air temp sensor. (See Fig. 4-o.)
B. Install the bracket using the bolts, nuts,
and washers supplied in the kit. Attach the
air filter in the wheel well.
C. On the engine compartment side, attach
the sleeve to the, 90° elbow, and the hose
clamps. Connect the other end of the air
intake assembly to the supercharger.
D. The brass fitting connected to the air
intake duct, (see Fig. 4-m) attaches to the
plastic fitting on top of the driver’s side
valve cover. (See Fig. 4-n.)
A. Raise the car up on jack stands. Remove
the right front tire and the fender liner.
Using the air intake bracket as a template,
mark the area on the inner fender well
where the 3 1/2" hole and the 4 holes will
be drilled. (See Fig. 4-l.)
*** NOTE ***
On 1999-2001 vehicles, step ‘A’ will not apply. Refer to
Appendix 1015935.
4-8 AIR INTAKE