TabletKiosk Sahara Slate PC i400 Series - Manual (Page 8)

Preface vii
The availability of some specific channels and/or
operational frequency bands are country dependent
and are firmware programmed at the factory to match
the intended destination. The firmware setting is not
accessible by the end user.
d. SAR Exposure
This device has been tested for compliance with FCC RF
Exposure (SAR) limits in typical flat configurations.
In order to comply with SAR limits established in the
ANSI C95.1 standards, it is recommended that the
integrated antenna is positioned more than 1.5cm from
your body or from nearby persons during extended
periods of operation. If the antenna is positioned less
than 1.5 cm (0.6 inches) from the user, it is
recommended that the user limit the exposure time.
FCC Statement to Users for the FaxModem
Notice of FCC Compliance for the Fax/Modem
This equipment complies with Part 68 of the FCC rules. The FCC
Registration Number and Ringer Equivalence Number for this
equipment are located on a label at the bottom of this
equipment. IF REQUESTED, THIS INFORMATION MUST BE GIVEN
TO THE TELEPHONE COMPANY.
The REN helps to determine the number of devices you may
connect to your telephone line while allowing all of those
devices to ring when your telephone number is called. In most,
but not all areas, the amount of devices connected to one line
should not exceed five (5).
To know precisely how many devices you may connect to your
line, as determined by the REN, you should contact your local
telephone company to determine the maximum REN for your
calling area.