Toyotomi FF-V30T - Manual (Page 27)

EXTENSION WIRE OF ROOM TEMPERATURE SENSOR
A room temperature sensor is located on the right side of the cabinet in front. The room temperature sensor is
installed in the sensor case. When the room temperature cannot be reached at the desired temperature depending
on the installation situation, the extension wire (*optional) is available to change the location. Please refer to the
following procedure.
1. Unfasten a screw to disassemble the sensor case on the cabinet with a driver.
2. Remove the connector by holding with fingers and attach the extension wire.
3. Attach the extension wire to the connector on the side of the room temperature
sensor.
4. Install the sensor case to the location where the room temperature can be reached
at the desired temperature.
26
FF_V30T_Type B_US.qxd 14.6.2 11:51 ページ 26