Zektor ProAudio 16™ DSP Preamp Audio Matrix - Manual (Page 35)

ClarityAudio Serial Protocol, Version 1.01, 11/8/12 33
Advanced Control
This command uses a bitmapped parameter to indicate which values are to be reset. A bit set to ‘1’
indicates the associated setting should be reset, a bit set to ‘0’ indicates the setting should not be reset
and the previous setting will remain unchanged.
Command formats:
^FS settings$ Reset the parameters indicated by ‘settings’
Response String:
There is no response string to the FS command, this command is write only.
Where ‘settings’ is a bitmapped parameter defined as:
Bit-0 - Reset zone input/output mappings, and power state
Bit-1 - Reset switch timings (the ‘DZ’ command settings)
Bit-2 - *Reserved*
Bit-3 - Reset control settings (the ‘XS’ command settings)
Bit-4 - *Reserved*
Bit-5 - Reset IP parameters
Bit-6 - *Reserved*
Bit-7 - *Reserved*
Bit-8 - Reset zones’ volume settings
Bit-9 - Reset zones’ audio parameters (bass, treble, eq, mute level, zone gains, zone lipsync, etc. all but volume)
Bit-10 - Reset source audio parameters (input gains, input lipsync delay)
Bit-11 - Reset global audio parameters (master volume, volume and mute fade times)
Value 32768 16384 8192 4069 2048 1024 512 256 128 64 32 16 8 4 2 1
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0