Analog Way MIDRA PLATFORM TPP Current Programmer's Guide - Manual (Page 22)

22
PROGRAMMER'S GUIDE FOR v01.02.11

<scrnT> parameter : This parameter gives the destination screen number. If only one screen is
available, due to device type or device mode, the screen number 0 shall be used.

<mem> parameter : This parameter gives the memory slot number to load. The allowed range of
values is 0 to 7, corresponding to memories 1 to 8.

<scrnF> parameter : This parameter gives the origin screen number, the one from which was recorded
the preset. Used with the <scrnT> parameter, they allow loading in a screen a preset stored from the
other, in matrix mode.
3.6.4 example of memorized preset recall
Picture 15 : example of memorized preset recall