4 u-boot command, U-boot deployment – Artesyn COMX-P2020 BSP User Guide (July 2014) User Manual
Page 45
U-boot Deployment
COMX-P2020 BSP User Guide (6806800L84B)
45
PCIE2 on bus 01 - 01
PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000)
Current Status: LSR-11, LTSSM-16, PEX width-x1, Clock-2.5GT/s
Scanning PCI bus 03
03 00 18ca 0027 0300 00
PCIE1 on bus 02 - 03
In: serial
Out: serial
Err: serial
Net: eTSEC1, eTSEC2, eTSEC3
Hit any key to stop autoboot: 0
=>
5.4
U-boot Command
To see a list of the available U-Boot commands, type "help" or "?". This will display a list of all
commands that are available in your current configuration.
Proceed as follows:
=> help
? - alias for 'help'
at24c02 - read/write at24c02
base - print or set address offset
bdinfo - print Board Info structure
boot - boot default, i.e., run 'bootcmd'
bootd - boot default, i.e., run 'bootcmd'
bootelf - Boot from an ELF image in memory
bootm - boot application image from memory
bootp - boot image via network using BOOTP/TFTP protocol