Audio Enhancement Product Manual - Manual (Page 49)

49
Installing the Bracket
Installing MTBR-07S Bracket for the Achiever, Elite II, IR-2007 or RA101 Receiver/Amplifier.
Please carefully read the following assembly, installation and safety instructions before
installing the MTBR-07S Bracket for the Achiever, Elite II, IR-2007 or RA101 Receiver/
Amplifier.
1 . Installation Surface: The enclosed accessories are suitable only for attaching to walls made
of solid concrete or wood studs . Do not install to sheet rock or wood panel .
2 . Tighten all the nuts using appropriate wrench .
3 . Make sure that MTBR-07S Bracket is installed so the tray is above average head height and
does not disturb free movement in hallways .
4 . You must test the MTBR-07S Bracket before setting the receiver/amplifier .
5 . The maximum weight allowed on the mount is 55 lbs . (0 .024947 mt) .
6 . Check that the receiver/amplifier is securely fastened to the bracket so it will not fall forward .
7 . One month after installation and every six months after that, check that MTBR-07S Bracket
is securely fastened to the wall and the screws and nuts are not loose . In case of weakening,
remove the receiver/amplifier, and strengthen all the points that have weakened .
8 . Before reinstalling MTBR-07S Bracket, remove the receiver/amplifier and then remount
according to the manual instructions .