Avalon Firestyles 34 DVL - Manual (Page 36)

36 Maintenance
© Travis Industries 4140813 100-01294
DANGER HIGH VOLTAGE: Disconnect power before attempting maintenance or repair.
Maintaining Your Heater's Appearance
Fingerprints or other marks left on the optional plated surface may become etched in place if they are not
wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft
cloth (with the heater cool). Other cleaners may leave a film that may become etched into the surface.
Accent Light Replacement
The accent light in your heater provides additional lighting. The bulbs will burn out over time. To replace,
follow the directions below:
 Shut off gas to the heater and let it cool for 15 minutes.
 Remove the glass (see page 22) and media.
 Replace the halogen bulbs with the following bulbs:
NOTE: Take care to not touch the bulbs with your fingers – use foam packing or a paper towel to
handle the bulbs:
35 Watt 120 Volt T4 Halogen Bulb (G6.35 Base)
Lower Accent Light
The lower accent light is located at the back of the firebox behind the light deflector, as shown below. It
can be removed by pulling it out.