Optional equipment – Avalon Firestyles 34 DVL User Manual
Page 45
Optional Equipment
(
for qualified installers only)
45
© Travis Industries
4140813
100-01294
6
Install the LP pilot orifice following the directions below.
(a) Use a 7/16” open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
7
Replace the firebox components.
8
The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to follow all the
directions. Disconnect the wiring from the stepper motor. Remove the stock stepper motor and replace with the
LP version – MAKE SURE IT IS CORRECTLY ORIENTED. Secure using the screws included with the motor,
and tighten to 25 Lb-inches. Leak-test this area after installing to verify proper installation. Re-attach the wiring.
9
Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line (if
applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve.
a
b
7/16" Wrench
Natural Gas Orifice = .020N (3way)
.018N (2way)
LP (Propane) Orifce = .014LP
.020N
or
.018N
.014LP