Avalon Firestyles 34 DVL - Manual (Page 7)

Installation (for qualified installers only) 7
© Travis Industries 4140813 100-01294
Installation Warnings
 Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
 This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
 The installation must conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the National
Gas and Propane Installation Code, CSA B149.1.
 In Manufactured or Mobile Homes must conform with Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home Installations,
ANSI/NCSBCS A225.1. This appliance may be installed in Manufactured
Housing only after the home is site located.
 The heater is designed to operate on natural gas, or propane (LP).
 All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
 Notify your insurance company before hooking up this heater.
 The requirements listed below are divided into sections. All requirements
must be met simultaneously. The order of installation is not rigid – the
qualified installer should follow the procedure best suited for the installation.
Packing List

Propane Conversion Kit (Orifices, Manifold Cover, etc.)

Top Convection Deflector

"Fireplace Altered" tag (attach to the fireplace)

Plugs for Surround Panels
 Remote
Control
Items Packed with the Face
 Face with attachment hardware
 Face Installation Instructions
Order of Installation
1 If the heater is to use propane, install the propane conversion kit (see page 43).
2 Install gas line into the fireplace (do not connect to unit).
3 Position the heater and connect the electrical line.
4 Connect the gas line and gas vent to the appliance.
5 Install the optional surround panels and trim.
6 Install the burner and media (logs or stones).
7 Follow the instructions under "Finalizing the Installation" on page 24.