Avalon Firestyles 34 DVL - Manual (Page 9)

Installation (for qualified installers only) 9
© Travis Industries 4140813 100-01294
Top Convection Deflector
Install the top convection deflector as
shown to the right.
The deflector is shipped on top of the
insert. The screws are shipped inside
the owner's pack.
Fireplace Requirements
 Insert must be placed within a code-conforming masonry fireplace or tested and listed factory-built
(metal) wood-burning fireplace. Repair any fireplace damage prior to installation.
 Because the insert uses a circulation blower, clean the fireplace, smoke shelf, and chimney prior to
installation.
 This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance
produces when determining a location.
Fireplace Sizing 3-Piece Panel 1-Piece Panel
Minimum Height
23-3/4” (604mm) 24-7/8” (632mm)
Minimum Width 31-1/2” (800mm) 32.5” (826mm)
Minimum Depth
14-1/2” (369mm)
or
15” (381mm)
Arched Faces
15-3/4” (400mm)
or
16-1/4” (413mm)
Arched Faces
Hearth Extension 1-1/4” (32mm) 0” (0mm)
The gas and electrical line should be installed prior to
installing the heater.
For tight fits (under 28”) see the section “Removing the
Vent Connector”
See “Leveling Bolts” for details on leveling the heater.
h Attach the “This fireplace has been altered…” plate to the fireplace (use two screws or other
suitable method). You may wish to place it in a location where it will be covered by the surround panels.
a
b
c
e
f
g
d
h
a
b
c
d
e
f
g