Installation (for qualified installers only), Exhaust restrictor – Avalon Firestyles 616 Diamond-Fyre User Manual
Page 16
16
Installation (for qualified installers only)
© Travis Industries
4140811
100-01331
Exhaust Restrictor
Set the exhaust restrictor to the position shown in the table below.
NOTE: The appliance will slow down within 5 to 10 minutes of startup due to the bi-metallic damper
closing. Make sure to wait for at least 10 minutes before assessing flame quality.
NOTE: The restrictor positions listed below are based upon laboratory testing. The optimum position may
vary slightly.
Natural Gas
(NG)
Height Position
Propane
(LP)
Height Position
15’ or less
Removed*
15’ or less
Removed*
15’ – 25’
#2 (Stock)
15’ – 25’
#2 (Stock)
25’ – 35’
#3
25’ – 40’
#3
35’ – 40’
#4
* If removing the restrictor, replace the screws into the holes in the firebox ceiling. Place the restrictor
plate near the appliance (in fireplace cavity) so it may be used at a later time if needed.
Restrictor adjustment should only be done by a qualified installer.