Avalon Firestyles 616 Diamond-Fyre - Manual (Page 41)

Maintenance 41
© Travis Industries 4140811 100-01331
DANGER HIGH VOLTAGE: Disconnect power before attempting maintenance or repair.
Maintaining Your Heater's Appearance
Fingerprints or other marks left on the optional plated surface may become etched in place if they are not
wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft
cloth (with the heater cool).
NOTE: Cleaners other than denatured alcohol may leave a film that may become etched into the surface.
Accent Light(s) Replacement
The accent light(s) in your heater provide additional lighting. The bulbs will burn out over time. To
replace, follow the directions below:
 Shut off gas to the heater and let it cool for 15 minutes.
 Remove the glass (see page 22), crushed glass, and media tray.
 Replace the halogen bulbs with the following bulbs:
NOTE: Take care to not touch the bulbs with your fingers – use foam packing or a paper towel to
handle the bulbs,
35 Watt 120 Volt T4 Halogen Bulb (G6.35 Base)
Upper Accent Light
The upper accent light can be accessed by removing the 4 screws with a ¼” nutdriver, as shown below.
The upper accent light assembly drops down to expose the accent light.