Avalon Firestyles 564 HO GS2 Installation - Manual (Page 25)

Installation (
for qualified installers only)
25
Travis Industries 4150330 100-01408
Diffuser Plate Adjustment
Certain vent configurations require the diffuser plate to be adjusted (refer to the approved vent
configuration charts for details). Position # 1 is stock (bent). Position # 2 is flattened.
Change the diffuser to position #2 as follows:
1. The diffuser is located above the exhaust restrictor (remove the restrictor if necessary).
2. Remove the diffuser.
3. Bend the round portion of the diffuser so it is flat (position #2).
4. Secure the flattened diffuser plate with the screws removed earlier.
5. Replace the exhaust restrictor. See “Exhaust Restrictor Adjustment” for the restrictor settings.
Back Wall of Firebox
Firebox Roof
DIFFUSER SIDE VIEW
Before (Stock - Position #1)
After (Position #2)
1/4” Nutdriver
4
3
2
1